Eclipse Systems,
Inc.
Compression
Style Sidelite Frame Installation Instructions
| ROUGH OPENING SHOULD BE NOMINAL DOOR WIDTH + INSIDE SIDELITE WIDTH + 3" AND NOMINAL HEIGHT + 3/4" | ||
| 1) INSTALL DOOR FRAME ACCORDING TO THE ECLIPSE DOOR FRAME INSTALLATION INSTRUCTIONS. | ||
| 2) INVERT AND INSERT GLAZING
SNAP-IN AT BASE AT DOOR FRAME STRIKE JAMB. SECURE SNAP-IN TO FLOOR
WITH STEEL PINS AND TO STRIKE JAMB WITH 1/2" SELF-TAPPING PAN HEAD
SCREWS.
3) ATTACH VERTICAL GLAZING SNAP-IN TO FULL LENGTH OF DOOR FRAME STRIKE JAMB. SECURE SNAP-IN TO JAMB USING 1/2" SELF-TAPPING PAN HEAD SCREWS SPACED 12" O.C. |
| |
| 4) PLACING GLAZING HEAD COMPONENT ON GROUND, INSTALL CORNER CLIP ON ONE END OF RAIL USING 1/2" SELF TAPPING PAN HEAD SCREWS |
| |
5) MAKE SURE "NOTCH" IN CLIP
 IS SECURED TIGHTLY AGAINST HEAD RAIL COMPONENT. INSTALL
GLAZING HEAD RAIL INTO ROUGH OPENING. |
| |
| 6) NOTCH END OF VERTICAL GLAZING RAIL, AS SHOWN, AND INSTALL OVER ROUGH OPENING. |
| |
| 7) SECURE VERTICAL GLAZING RAIL SLIDING CORNER CLIP FROM HEAD COMPONENT INTO GLAZING POCKET IN VERTICAL LEG. WITH CORNER AND GLAZING POCKETS ALINED SECURE WITH 1/2" SELF TAPPING PAN HEAD SCREWS THROUGH CLIP INTO EACH VERTICAL LEG |
| |
| 8) SNAP GLAZING SILL OVER INVERTED RAIL AT THE BASE OF THE SIDELITE |
| |
|
Eclipse Systems, Inc., | ||
