Eclipse Systems,
Inc.
Compression System - Glazing Mullion
Instructions
|
VERTICAL MULLION | ||
|
|
1) PRE DRILL THE MULLION CLIPS FOR #7
SIZE SCREWS (4 CLIPS PER MULLION). |
|
|
2) ATTACH THE LONG SIDE OF THE CLIPS TO THE TWO SCREW RACEWAYS WITH 3/8" X #7 PAN HEAD SCREWS, WHILE HOLDING THE CLIPS 1/16" BACK FROM THE END OF THE GLAZING RAIL. REPEAT THIS AT THE OTHER END OF THE RAIL . HOLDING THE CLIPS BACK 1/16" PULLS THE MULLION TO THE JAMB FOR A TIGHTER FIT. | ||
 |
3) CUT A 1-1/2" PIECE OF SILL SNAP-ON STOP. SNAP THE PIECE ON THE SILL WHERE THE MULLION IS TO BE LOCATED. |  |
| 4) POSITION THE GLAZING RAIL (WITH CLIPS INSTALLED) AT THE REQUIRED LOCATION, BETWEEN THE HEAD AND SILL. ATTACH THE RAIL USING 1/2" SELF DRILLING SCREWS THROUGH THE SHORT SIDE OF THE CLIP INTO THE SILL AND HEAD. SNAP THE GLAZING SNAP-IN INTO THE ATTACHED RAIL TO COMPLETE THE MULLION. | ||
|
HORIZONTAL MULLION | ||
|
|
1) PRE DRILL THE MULLION CLIPS FOR #7 SIZE SCREWS (4 CLIPS PER MULLION). | |
| 2) ATTACH THE LONG SIDE OF THE
CLIP ON THE END OF THE SILL UNDER WHERE THE STOP SNAPS ON, WITH 3/8"
X #7 PAN HEAD SCREWS. HOLD THE CLIP 1/16" BACK FROM THE END OF THE
SILL. MAKE CERTAIN THE SCREW PLACEMENT DOES NOT INTERFERE WITH THE
SNAP-ON STOP. IN THE SAME MANNER, ATTACH ANOTHER CLIP TO THE "T"
PORTION ON THE UNDERSIDE OF THE SILL. REPEAT THIS AT THE OTHER END
OF THE SILL.
HOLDING THE CLIPS BACK 1/16" PULLS THE MULLION TO THE SILL & HEAD FOR A TIGHTER FIT. |
| |
| 3) POSITION THE GLAZING SILL (WITH CLIPS INSTALLED) AT THE REQUIRED LOCATION, BETWEEN THE GLAZING JAMBS. ATTACH THE SILL USING 1/2" SELF DRILLING SCREWS THROUGH THE SHORT SIDE OF THE CLIP INTO THE JAMBS. SNAP THE GLAZING SNAP-IN INTO THE ATTACHED SILL TO COMPLETE THE MULLION. |
| |
|
|
Eclipse Systems, Inc.,
| |
