Eclipse Systems,
Inc.
Compression System - Borrowed Lite Frame
Instructions
| 1) CUT HEAD COMPONENTS OF GLAZING RAIL TO EXACT FINISH DIMENSION. PLACING HEAD COMPONENT ON GROUND, INSTALL CORNER CLIP ON EACH END OF RAIL USING 1/2" SELF TAPPING PAN HEAD SCREWS |
| |
|
2) MAKE SURE "NOTCH" | ||
| 3) CUT LEG COMPONENTS OF GLAZING RAIL TO EXACT FINISH DIMENSIONS. NOTCH TOP END OF RAIL AS SHOWN. |
| |
| 4) SECURE VERTICAL GLAZING RAIL SLIDING CORNER CLIP FROM HEAD COMPONENT INTO GLAZING POCKET IN VERTICAL LEG. WITH CORNER AND GLAZING POCKETS ALINED SECURE WITH 1/2" SELF TAPPING PAN HEAD SCREWS THROUGH CLIP INTO EACH VERTICAL LEG. |
| |
| 5) CUT SILL & STOP COMPONENTS TO EXACT FINISH DIMENSION. FOR FLOOR MOUNT ATTACH A SECTION OF GLAZING SNAP-IN, UPSIDE-DOWN, TO THE FLOOR. INSTALL CORNER CLIP ON EACH END OF SILL AS IN STEP 1. SLIP SILL OVER WALL (OR SNAP-IN PIECE). SET GLASS WITH WET GLAZING COMPOUND AND INSTALL STOP. |
| |
|
Eclipse Systems, Inc., | ||
IN CLIP IS SECURED TIGHTLY AGAINST HEAD RAIL COMPONENT.
INSTALL HEAD RAIL INTO ROUGH OPENING. 
